Reproduction of the Left (Drivers Side) Exhaust Resonator Muffler Hanger Bracket.
Chrysler Master Parts Catalog
1970 including T/A & AAR 1971 1972 1973 1974
Plymouth Barracuda & Cuda
This is the bracket that is bolted onto the floor pan under the rear seat area when using dual exhaust.
The factory welded the right side to the floor pan as all were produced with single or dual exhaust used the right one, when a car was built with dual exhaust the factory drilled out the pre pressed in nibs in the floor pan and used this bracket which is what the rubber hanger strap is bolted to.
If you are converting a single exhaust E Body to duals you will need this bracket for the left (drivers side) to bolt your rubber hanger to. Easy to install as the factory pre marked the floor pan where the holes need to be drilled.
Comes with inner and outer bracket and clip and fasteners as shown.
Licensed by FiatChrysler To Dale's Cuda Shop Where Applicable.